Lab Equipment

Product Details:

•   Max Temp.

•  Zone 1/2/3 : 1200°C

Working Temp.: 1100°C

  Temp. Accuracy: ±1°C

•   Minimum Heating Rate: ≤1°C /min
Max. Heating Rate: ≥ 20°C /min

HEATING ELEMENT:  Kanthal A1 wire Coil type with end connections
Inner Chamber: Ceramic Board with heating elements placed on the side of walls.

Ø  Insulation: High-purity fibrous alumina insulation for blocking heat radiation from inside the tube

Ø  Construction: Triple walled with air insulation on the outer side For Minimal Skin Temp less than 50°C.

Ø  Body: Made of mild steel duly powder coated.

Quartz Tube size: Inner Dia. 70mm/ Hot Zone length 200mm & overall length 1000mm. Inner Chamber having constant temperature heating zone.

Ø  Temp. Control :The temperature is controlled and programmed by 3 independent fully automatic programmable temperature controllers (one for each zone. 30 segments for each PID automatic digital control thus for heat rate control.

Ø  Power Control: SSR unit with current limit and soft start facility and step down air cooled transformer

Ø  Sensor: Cr/Al for each zone

Ø  Safety: Overcurrent Short Circuit Protection. Thermocouple breaks alarm. High temp. Alarm.

Ø  Control Panel:   Control Panel consists of Mains MCB Switch, Profile Programmer, Indicator Lights, and Ammeter. Suitable for 230V AC Single Phase Operation.

 

Ø  Four Cooling Fans are also fitted at bottom side of furnace for cooling of the furnace

Additional Information:

• Item Code: DISF-11H

Product Details:

We are Engaged in offering wide range of quality products to our clients , our products are really appreciated by our clients.

Product Details:

These environment Test Chambers can satisfy a variety of enviromental condition. they are especially suitable for the simulation of fixed temperature and relative humidity values above freezing point. Constructed of double walls, the exterior is made of sheet steel, the interior of stainless steel 304. A flush fitting insulated door has leak proof gasket. The shelf position of trays is adjustable. The rear chamber of the interior is fitted with a refrigeration evaporator, heater and powerful air circulating fan to create a positive air flow through the chamber. A hermetically sealed ISI mark, CFC Free compressor below the chamber provides temperature below ambient. The same compartment houses boiler with an immersion heater and water level controller creating humidity. Safety circuit  which cuts of system and stop unit in case of malfunction of Controller. Audio Visual alarm with cut out for low water level. The control panel comprises of ON/OFF switches, Microprocessor based digital Temp. Indicator-cum-controller (Direct Display of Humidity in % RH), indicating lamps and protective fuses. 
Supply : 220Volts, 50Hz, single phase AC supply.
OPTIONALProgrammable Digital temperature & humidity Controller having 1 Programme X 16 segments (ramp/soak), to set the temp. & humidity profile w.r.t time as per user requirement. The 16 steps are freely formatable.Chamber illumination with 3 nos. fluorescent tubes of 60cm length placed vertically along the black wall. Separate ON/OFF switch for tubes and min. temp. can be obtained form 10 to 500C when all the Tubes are ON. With Timer 0-24 hours for regulating cyclic illumination condition fixed on the top of the chamber.Data logger with LCD display having memory to store 1 Lakh records of temp., humidity (%RH) & time. The data can be copied on pen drive & viewed on excel sheet on computer.Surge tank of capacity 100Ltr. made of plastic having water circulation pump & automatic water filling arrangement to fill the humidity tank automatically. This ensures uninterrupted operation of the chamber for 4 to 5 days.